mirror of
https://github.com/rstrouse/ESPSomfy-RTS.git
synced 2026-10-31 22:02:17 +01:00
77237111ea
The edit routes become ops 26-44 (addRoom ... groupSortOrder): ProtoEdits turns an op's payload into the route's request, full names and real booleans, and loop() applies it with applyModelEdit() as the route does. The reply goes to the client that sent it, with an add's new id, or the route's reason and a shade's validation code; the HTTP routes keep sending requestResult. getNextRoom, getNextShade, getNextGroup and groupOptions (45-48) are answered by loop() from the shade model, through a new LoopQueue item. Messages that arrive in pieces, a frame over one TCP segment or several frames, are put back together by ProtoAssembly: one at a time across clients, up to 4 KB, in a buffer held only while one is on its way. A message in pieces is now told from its first frame's opcode, which also stops a fragmented message's last frame drawing a second reply. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
19 lines
1.4 KiB
Markdown
19 lines
1.4 KiB
Markdown
# e2e suite
|
|
|
|
Runs against a real device on your network, by hand, never in CI. It checks socket protocol 2 ([PROTOCOL.md](../../docs/PROTOCOL.md)) and that the device survives the loads that used to run its heap out.
|
|
|
|
```sh
|
|
~/.platformio/penv/Scripts/uv run --no-project --with pytest -- pytest test/e2e --device 192.168.1.120
|
|
```
|
|
|
|
| Option | Use |
|
|
|---|---|
|
|
| `--device` | the device's address (required) |
|
|
| `--password`, `--username` / `--pin` | the credentials of a Secured device |
|
|
| `--radio --shade <id>` | also send real commands: that shade moves a little and back |
|
|
| `--edit` | also add a room and delete it again |
|
|
| `--record` | save hello, the sync and the schema to `test/fixtures/proto2/`, for the web UI and Home Assistant tests |
|
|
|
|
A plain run sends nothing on air, changes no settings and doesn't reboot the device. The command tests send ops that are refused before they reach the radio, and one `setPositions` that sets a shade to the position the sync gave: that drops the fraction of a percent the shade's believed position may have had. The edit tests send edits that are refused, and one shade sort order set to the order it has, which saves the shades again unchanged. It does fill every socket slot for a few seconds, and replays a page load.
|
|
|
|
The tests run in whatever security mode the device is in; the suite never changes it. To test both modes, run the suite once in each.
|