* Support for integrated tilt types
* Increased linked remotes to 7 #25.
* Fixed issue #25 by increasing JSON buffer
* Changed software sync detection for linked remotes to better match on sync #26
* Moved shade storage from NVS. NVS storage became limited because of the wired ethernet boards. This limited the number of potential shades to around 20.
* Added the ability to backup the shade configuration
* Added the ability to restore the shade configuration.
* Increased up. down, and tilt timing value to allow for up to 54 days of transition. The previous 16bit value did not allow for very slow shades and was limited to just over a minute.
* UI cleanup and additional messages.
* Transceiver tuning now applies the rx bandwidth in the proper order so no reboot is required.
* Fix radio pin settings where the old values were being set to the config then reloaded. This meant that the new pin settings were not being saved.
* Disable the radio when the radio cannot be configured. This stops the microcontroller from hitting a hard halt and allows the pin settings to be changed.
* Add ethernet configuration options in preparation for boards with ethernet connections.
Originally the address used for the SSID would become inconsistent because of the way the ESP32 uses the string class to store the SSID. This would eventually end in an emit that crashed the socket from the client with an inconsistent UTF-8 byte. The fix was to convert the string to a pointer for the emits.
* My button long presses detected from remotes for setting the my button.
* Allow setting of rolling code.
* Tuning for position setter and reading of hw sync bytes for repeats.
* Increased the number of APs that can be queried and filtered out those that have an RSSI -95. Previously, the number of returned SSIDs could blow the output buffer.
* Do not disable the Save button during scan of potential APs. If the scan is taking a long time you should just be able to type it in.
* If a connection is lost and cannot be recovered fall back to AP mode to allow resetting the creds without power off.
* Reduced socket traffic on load.
* Added code to check max socket connections and reconnect when a slot becomes available.
* Improve load times for Shade Manager
