- Intégration du contrôleur Ethernet W5500 via SPI pour les cartes
comme Waveshare ESP32-S3 POE
- Configuration des pins SPI (MOSI, MISO, SCLK, CS, INT, RST) via
l'interface web
- Utilisation directe des APIs ESP-IDF pour le W5500 car la classe
Arduino ETH ne supporte pas nativement ce contrôleur
- Gestion manuelle du DHCP et DNS pour le W5500
- Protection des appels ETH Arduino quand W5500 est utilisé
- Désactivation temporaire de la vérification OTA GitHub pour W5500
(problème de compatibilité HTTPClient)
- Ajout des presets de cartes dans l'interface (Waveshare, etc.)
* Support for integrated tilt types
* Increased linked remotes to 7 #25.
* Fixed issue #25 by increasing JSON buffer
* Changed software sync detection for linked remotes to better match on sync #26
* Moved shade storage from NVS. NVS storage became limited because of the wired ethernet boards. This limited the number of potential shades to around 20.
* Added the ability to backup the shade configuration
* Added the ability to restore the shade configuration.
* Increased up. down, and tilt timing value to allow for up to 54 days of transition. The previous 16bit value did not allow for very slow shades and was limited to just over a minute.
* UI cleanup and additional messages.
* Transceiver tuning now applies the rx bandwidth in the proper order so no reboot is required.
* Fix radio pin settings where the old values were being set to the config then reloaded. This meant that the new pin settings were not being saved.
* Disable the radio when the radio cannot be configured. This stops the microcontroller from hitting a hard halt and allows the pin settings to be changed.
* Add ethernet configuration options in preparation for boards with ethernet connections.
