diff --git a/Mini-ESP32s3-Device-Build.md b/Mini-ESP32s3-Device-Build.md
index 01902e5..3281aee 100644
--- a/Mini-ESP32s3-Device-Build.md
+++ b/Mini-ESP32s3-Device-Build.md
@@ -96,7 +96,7 @@ Position the assembly into the enclosure and mark where the USB connector and ra
 
 With the and antenna in place I used some scrap ABS plastic and glued a couple of stops in place.  I used ABS glue for black plastic pipes to glue it in place as it dries in about 5 minutes.
 
-After you have fit the case to your liking, position the antenna on top of the board and close up the case.  In the end I did not affix the antenna to the lid of the case since it makes it easier to remove the lid without damaging the antenna.  I simply positioned it all carefully to ensure the antenna was not getting closed up by the antenna and snapped on the lid.
+After you have fit the case to your liking, position the antenna on top of the board and close up the case.  In the end I did not affix the antenna to the lid of the case since it makes it easier to remove the lid without damaging the antenna.  I simply positioned it all carefully to ensure the antenna was not getting closed up by the lid and snapped it together.  If the antenna is a little loose or the board moves around glue a couple of pieces of scrap ABS plastic to secure the board in place.
 
 ![image](https://github.com/rstrouse/ESPSomfy-RTS/assets/47839015/79be19ec-4f5f-4769-a60e-bfdfb93b6488)