From 5592b35dcef288631ae3598467f2763bceec20c1 Mon Sep 17 00:00:00 2001 From: rstrouse <47839015+rstrouse@users.noreply.github.com> Date: Fri, 1 Sep 2023 14:15:28 -0700 Subject: [PATCH] Updated Simple ESPSomfy RTS device (markdown) --- Simple-ESPSomfy-RTS-device.md | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/Simple-ESPSomfy-RTS-device.md b/Simple-ESPSomfy-RTS-device.md index f8483d6..9b85b23 100644 --- a/Simple-ESPSomfy-RTS-device.md +++ b/Simple-ESPSomfy-RTS-device.md @@ -114,7 +114,9 @@ This is a wired ethernet model that allows you to connect via a wired ethernet c GPIO 02 may need to be disconnected during initial firmware load or the firmware load will fail. After that you can use the OTA upload features for loading firmware onto ESPSomfy RTS from any connected device. ## Olimex ESP32-PoE/EVB -This little board uses power over ethernet so you can run one cable to the device without any additional power requirements. There are more available pins on this device so you have a few more choices than the WT32-ETH01 boards. However, here is a suggestion for the configuration. All of the pins below are on the UEXT connector so if your build a connector then you can simply connect it between the transceiver and the connector header. There will be no need for a breadboard. Kinda dumb that there are no mounting holes though. +This little board uses power over ethernet so you can run one cable to the device without any additional power requirements. There are more available pins on this device so you have a few more choices than the WT32-ETH01 boards. However, here is a suggestion for the configuration. All of the pins below are on the UEXT connector so if your build a connector then you can simply connect it between the transceiver and the connector header. There will be no need for a breadboard. As a bonus this board already has a micro-USB connector, so you do not need a USB to serial converter to load the initial firmware. + +While earlier revisions of this board had no mounting holes, revision L now has mounting holes as well as protection for the ethernet PHY if you buy the ISO model. If you do not have an ISO model then you should not connect the POE and USB connector at the same time. | Pin | Description | ESP Pin | | --- | ----------- | ------- |