* Support for integrated tilt types
* Increased linked remotes to 7 #25.
* Fixed issue #25 by increasing JSON buffer
* Changed software sync detection for linked remotes to better match on sync #26
* Fixes issue #11 TX Power is now persisted to NVS
* Increase timing for tilt motors from 7 to 15 beats. #1
* Add time to frame log.
* Allow RX and TX pins to be shared and multiplexed
* Moved shade storage from NVS. NVS storage became limited because of the wired ethernet boards. This limited the number of potential shades to around 20.
* Added the ability to backup the shade configuration
* Added the ability to restore the shade configuration.
* Increased up. down, and tilt timing value to allow for up to 54 days of transition. The previous 16bit value did not allow for very slow shades and was limited to just over a minute.
* UI cleanup and additional messages.
* Transceiver tuning now applies the rx bandwidth in the proper order so no reboot is required.
Added api services to support blind definitions in Home Assistant. Stop tilt function when my button is pressed and the tilt operation is in progress. Bump to v1.3.2
* Fix radio pin settings where the old values were being set to the config then reloaded. This meant that the new pin settings were not being saved.
* Disable the radio when the radio cannot be configured. This stops the microcontroller from hitting a hard halt and allows the pin settings to be changed.
* Add ethernet configuration options in preparation for boards with ethernet connections.
All object references not look for cached script file. This eliminates the need to reload the script when simply rendering the page. ESP32 does not need to download this data if the cache already has it. Implemented versioning on the script tags.
* My button long presses detected from remotes for setting the my button.
* Allow setting of rolling code.
* Tuning for position setter and reading of hw sync bytes for repeats.
* Increased the number of APs that can be queried and filtered out those that have an RSSI -95. Previously, the number of returned SSIDs could blow the output buffer.
* Do not disable the Save button during scan of potential APs. If the scan is taking a long time you should just be able to type it in.
* If a connection is lost and cannot be recovered fall back to AP mode to allow resetting the creds without power off.
