Init() starts the SPI bus and resets the chip, then every register write
calls SpiStart() again while the bus is still up. SpiStart() ran pinMode()
on SCK, MOSI and MISO. On Arduino 3.x that takes the pins from the SPI bus,
which stops it (spiStopBus) while SPIClass still holds the handle, so the
following SPI.begin() returns early and the bus stays down.
On the S3 the stopped bus also has clk_gate cleared, so spiTransferByte()
waits on cmd.usr forever and the task watchdog aborts async_tcp when the
radio settings are saved. On the ESP32 the transfer completes on detached
pins, so the first register write (FSCTRL1) is silently lost.
SPI.begin() attaches and configures the bus pins itself, so on ESP32
targets SpiStart() now only sets SS, which the driver drives by hand.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Arduino 3.x tracks which peripheral owns each pin and logs when a pin the
SPI bus owns is used through digitalRead()/digitalWrite(). The vendored
SmartRC-CC1101 driver does both:
- Every register access waits for CHIP_RDYn with digitalRead(MISO): one
"IO 19 is not set as GPIO" warning per access, about one every 4 s from
the RSSI read in decodeFrame(). It now reads the pad with gpio_get_level(),
which returns the same level without the ownership check.
- Init() set SCK and MOSI with digitalWrite() after SpiStart(), which the core
refused with an error each boot. The writes are gone; the bus idles them.
The MISO wait also had no bound, so a missing or dead module hung the caller.
It now gives up after 10 ms.
No native test: the driver only builds for the ESP32. To check on hardware:
the serial log should have no "is not set as GPIO" lines, and frames should
still decode with an RSSI.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Copied from the registry package lsatan/SmartRC-CC1101-Driver-Lib@2.5.7
(upstream unmaintained since 2021) so it can be fixed for Arduino 3.x in
the next commit. This commit is the untouched copy, so that diff shows
every change. Licence: LICENSE.txt ("permission to modify and publish").
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Drop files the Arduino PlatformIO build never reads: the ESP32 SVD,
the ESP-IDF CMakeLists/idf_component.yml, the PlatformIO template
READMEs, and the already-ignored debug.cfg. Fix the esp32.vsd typo in
.gitignore so the SVD stays ignored.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
