fix: review fixes for the boot pin warnings

- The backup record's fallback RX pin is 35, as the radio's default is.
- BootPins.h, pins.js and Transceiver.cpp say to keep the pins, the radio
  pins checked and the shared RX/TX rule in step.
- index.js reads the chip model through one chipModel().
- BootPins.RADIO is RADIO_PINS; the P4 test builds its config once.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

src/BootPins.h

@@ -9,7 +9,9 @@
 // the firmware.  The ROM reads them before any code runs, so a radio that
 // drives one at power-up stops the board booting until EN is pressed (issue
 // #34).  The strapping pins that only pick a download mode, quiet the boot
-// log or set the SDIO timing aren't listed.  web UI: data-src/js/pins.js.
+// log or set the SDIO timing aren't listed.  The web UI has the same pins in
+// data-src/js/pins.js, and checks the same radio pins as
+// transceiver_config_t::apply(): keep the three in step.
 //
 // Returns what the pin does at reset, or nullptr for a pin that can't stop
 // the boot.

src/ConfigRecords.h

@@ -183,7 +183,7 @@ struct trans_record_t {
   uint8_t MOSIPin = 23;
   uint8_t MISOPin = 19;
   uint8_t TXPin = 13;
-  uint8_t RXPin = 12;
+  uint8_t RXPin = 35;
   float frequency = 433.42;
   float rxBandwidth = 99.97;
   float deviation = 47.60;

src/Transceiver.cpp

@@ -605,7 +605,7 @@ void transceiver_config_t::apply() {
       ESP_LOGD(TAG, "Applying radio settings - Setting Data Pins RX:%u TX:%u", this->RXPin, this->TXPin);
       // The pins the CC1101 drives at power-up, before it is set up: GDO0
       // puts out a clock, GDO2 CHIP_RDYn, and SO follows CHIP_RDYn while CSN
-      // is low.
+      // is low.  The web UI checks the same (data-src/js/pins.js).
       warnBootPin("TX", this->TXPin);
       if(this->RXPin != this->TXPin) warnBootPin("RX", this->RXPin);
       warnBootPin("MISO", this->MISOPin);